Modifi3D the 3D Print Finishing Tool
Modifi3D the 3D Print Finishing Tool : Finish - Repair - Modify
Modifi3D is a tool which repair, finish or modify your 3D prints . It heats up in less than 15 seconds and switch to sleep mode if not used for 25 seconds.
4 interchageable tips to finish your printings.
Knife tip for cutting, removing sections or supports, brims ans rafts from your 3D print.
Needle tip for clearing small holes and features or for detailes layer refinements in hard reach place.
Point tip for larger internal features and holes.
Scoop tip for removing stringing and imperfections from inside holes or recesses.
- USB pwered (USB 2.0 ou 3.0)
- Basic stand included
Modifi3D in action : vidéo
Accessories : Set of replacement tool kit
Made in UK
Photos are not contractual.